Exhaust condensate drain Autoterm
For all installation situations where a falling exhaust pipe cannot be guaranteed and a 3mm hole in the exhaust hose (at the lowest point) is not a solution because hot water must not drip into the environment.
Especially on boats, in 99% of cases the heater is below the level of the hull duct and the condensate would run back into the heater. The special condensate drain provides a 90° angle for the lateral discharge of the exhaust gas and at the same time has a drain cooled by a copper spiral for the condensate that occurs. The copper coil can be bent if necessary and depending on the installation situation.
An elegant plug & play solution for all 24mm exhaust systems.
Item weight: |
0,11 kg |
|
Dimensions packing
( l × w × h ):
|
200,00 × 100,00 × 40,00 cm |
All reviews: