Control panel for boat or motorhome with REMOTE Panel
The original tigerexped control panel with freely assignable ports, which can be individually programmed as switches or buttons, brings the operation of all your devices to one central place - extremely flexible and visually appealing.
Separate assembly of control box and panel
While the control box with all the consumer connections can be installed in the electrical compartment / cabinet, the panel can be conveniently led to any location with just a single micro USB cable up to 5 m in length. Instead of an installation depth through the connections, it only requires a hole to feed the USB cable through.
Note on the micro USB cable: The cable is not included in the scope of delivery and can be purchased as a standard product depending on the desired length. Please make sure that it is properly shielded, so do not buy a very cheap product!
IP67 certified
The control unit is water-protected and certified according to the IP67 standard, which means it can withstand submersion up to 1 meter in water for a maximum of 30 minutes. It is therefore suitable for use in areas where there is a risk of splashing water on deck.
On the other hand, IP67 confirms that the device is dust-tight and is protected even on expedition vehicle tours through desert areas with extremely fine dust (which experience has shown does not stop at even the smallest opening).
The control panel has a completely closed membranefoil surface for this purpose.
Fully flexible options
All buttons are freely configurable as switches or Buttons!
Bluetooth
Device can be configured and operated by smartphone (Android / iOS)!
Circuit protection
The circuit protection is guaranteed for each port by an integrated, resettable 10A fuse.
Switchboard 12V AND 24V suitable
The permissible operating voltage for our original tigerexped switchboard with remote panel is between 11 and 30 volts. It can therefore be operated with both 12 and 24 volt on-board voltage without any Problems.
Connection consumers
All consumers are connected to the control box using flat plugs.
Power supply connection
The power supply is fed to the control box by a screw connection on the side housing.
Connect the control panel
All information on connecting the control panel and the configuration of the buttons can be found under the menu item “PDF”.
manufacturer information:
texdev GmbH
Weseler Str. 82
Alpen, 46519
NRW, DE
info@texdev.de
responsible person:
texdev GmbH
Weseler Str. 82
Alpen, 46519
NRW, DE
info@texdev.de
Item weight: |
0,30 kg |
All reviews: